XADM: Installing Dynamic RAS Connector without RAS Installed
Article ID: 147107
Article Last Modified on 10/28/2006
APPLIES TO
- Microsoft Exchange Server 4.0 Standard Edition
- Microsoft Exchange Server 5.0 Standard Edition
- Microsoft Exchange Server 5.5 Standard Edition
This article was previously published under Q147107
SUMMARY
When you install a Microsoft Exchange Dynamic Remote Access Service (RAS)
Connector on an Microsoft Exchange Server that does not have Windows NT RAS
installed, the required Microsoft Exchange RAS Message Transport Agent
(MTA) Transport stack will not install. This will prevent the installation
of the Dynamic RAS Connector.
MORE INFORMATION
The Dynamic RAS Connector is dependent upon Windows NT RAS. When this
service is not installed, the Dynamic RAS connector will not function.
To install the Dynamic RAS connector, Windows NT RAS will need to be
installed from the Windows NT Control Panel by starting the Network applet,
choosing Add Software, and choosing Remote Access Service.
If the Dynamic RAS Connector is going to be scheduled as Remote Initiated,
the Windows NT RAS can be set to Receive Calls Only.
If the Dynamic RAS Connector is going to scheduled as Always or Scheduled
times, but will never receive a call, the Windows NT RAS can be set to Dial
Out Only.
Keywords: kbhowto kbsetup kbusage KB147107