KB149675 - XFOR: Error Sending Mail from Exchange out an MHS Gateway

MORE INFORMATION

Check the following configuration in the Microsoft Exchange Administrator program:

Verify that the Address Space on the PC Mail Connector has:
```
   TYPE    Address                   COST
   MHS                                  1
						
```
If MHS is not a type, use New General to add it. Then Stop and Start the PC Mail Connector service.
Verify that the Site, Configuration, Site Addressing Object, Routing Tab for the MHS address is defined properly. If it is not, go back to step one and remove and recreate the address space.
Recalculate Routing on the Site, Configuration, Site Addressing Object, Routing tab.
On the MS Mail connector Properties Connections tab, verify that the Access component is hanging off the gateway PO. If it is there, but is not shown under the gateway MS Mail PO, remove the access component from the connector PO and reinstall it, so that it is pointing to the MS Mail gateway PO.