Microsoft Knowledge Base

BUG: Too Many Shaders in a Scene Can Cause 3D to Quit
Last reviewed: April 19, 1996
Article ID: Q149738
The information in this article applies to:
  • Softimage 3D for IRIX, version 3.0

SYMPTOMS

Depending on the system configuration, there is a limit to the number of shaders you can have in a scene. Too many shaders can cause Softimage 3D to quit either when reloading scenes or when re-saving scenes. This has nothing to do with the actual scene.

RESOLUTION

Depending on the system configuration, ensure that you do not exceed approximately 150-200 shaders per scene.

STATUS

Softimage has confirmed this to be a bug in the Softimage product listed at the beginning of this article. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.

NOTE: Softimage Inc. is a wholly owned subsidiary of Microsoft Corporation.

Additional reference words: 3.00
KBCategory: kbgraphic kbbuglist
KBSubcategory: si si3d



THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: April 19, 1996
©1997 Microsoft Corporation. All rights reserved. Legal Notices.