Contents

1   Introduction

This document describes how to configure the Node Credential for ECLI or NETCONF.

1.1   Prerequisites

This section describes the prerequisites, which must be fulfilled before using the procedure.

1.1.1   Conditions

The following conditions must apply:

• An Ericsson Command-Line Interface (ECLI) in exec mode is in progress.
• A known NodeCredential Managed Object (MO) exists; in these examples, NodeCredential=1 is used.

2   Procedure

2.1   Configure Node Credential for ECLI

To configure the Node Credential for ECLI:

1. Navigate to the CliTls MO, for example:

   >dn ManagedElement=1,SystemFunctions=1,SysM=1,CliTls=1

2. Enter Config mode:

   (CliTls=1)>configure

3. Set the reference to the applicable NodeCredential MO, for example:

   (config-CliTls=1)>nodeCredential="ManagedElement=1,SystemFunctions=1,SecM=1,CertM=1,NodeCredential=1"

4. Commit the settings:

   (config-CliTls=1)>commit

5. Verify the settings:

   (CliTls=1)>show

   The following is an example output:

   CliTls=1 [...] nodeCredential="ManagedElement=1,SystemFunctions=1,⇒ SecM=1,CertM=1,NodeCredential=1"

2.2   Configure Node Credential for NETCONF

To configure the Node Credential for NETCONF:

1. Navigate to the NetconfTls MO, for example:

   >dn ManagedElement=1,SystemFunctions=1,SysM=1,NetconfTls=1

2. Enter Config mode:

   (NetconfTls=1)>configure

3. Set the reference to the applicable NodeCredential MO, for example:

   (config-NetconfTls=1)>nodeCredential="ManagedElement=1,SystemFunctions=1,SecM=1,CertM=1,NodeCredential=1"

4. Commit the settings:

   (config-NetconfTls=1)>commit

5. Verify the settings:

   (NetconfTls=1)>show

   The following is an example output:

   NetconfTls=1 [...] nodeCredential="ManagedElement=1,SystemFunctions=1,⇒ SecM=1,CertM=1,NodeCredential=1"