Contents

1   Introduction

This document describes how to create an SNMPv2C target. An SNMPv2C target is created to forward Simple Network Management Protocol (SNMP) notifications to a management system over the SNMPv2C protocol.

1.1   Prerequisites

This section describes the prerequisites, which must be fulfilled before using the procedure.

1.1.1   Conditions

The following conditions must apply:

• The SNMP community and target IP address are known and according to the network IP plan.
• An Ericsson Command-Line Interface (ECLI) session in Exec mode is in progress.

2   Procedure

To create an SNMPv2C target:

1. Navigate to the Snmp Managed Object (MO), for example:

   >dn ManagedElement=NODE06ST,SystemFunctions=1,SysM=1,Snmp=1

2. Enter Config mode:

   (Snmp=1)>configure

3. Create an SNMPv2C target, for example:

   (config-Snmp=1)>SnmpTargetV2C=OSS_v2C

4. For the SnmpTargetV2C MO, set attributes community and address, for example:

   (config-SnmpTargetV2C=OSS_v2C)>community=public

   (config-SnmpTargetV2C=OSS_v2C)>address=192.0.2.10

5. Commit the settings:

   (config-SnmpTargetV2C=OSS_v2C)>commit

6. Verify the settings

   (SnmpTargetV2C=OSS_v2C)>show -v

   The following is an example output:

   SnmpTargetV2C=OSS_v2C address="192.0.2.10" administrativeState=UNLOCKED <default> community="public" informRetryCount=1 <default> informTimeout=300 <default> isMibWritable=true <default> operationalState=ENABLED [] <read-only port=162 <default> snmpTargetV2CId=OSS_v2C transportMethod=TRAP <default>