Contents

1   Introduction

This document describes how to delete a Simple Network Management Protocol (SNMP) target. An SNMP target can be deleted when it is no longer needed to send SNMP notifications to a given management system. This could be, for example, as a result of replanning.

1.1   Prerequisites

This section describes the prerequisites, which must be fulfilled before using the procedure.

1.1.1   Conditions

The following conditions must apply:

• The SNMP target to delete is known and according to the network IP plan.
• An Ericsson Command-Line Interface (ECLI) session in Exec mode is in progress.

2   Procedure

To delete an SNMP target:

1. Navigate to the Snmp managed object, for example:

   >dn ManagedElement=NODE06ST,SystemFunctions=1,SysM=1,Snmp=1

2. To find the SNMP target to be deleted, show the existing SNMP targets:

   (Snmp=1)>show -v

   The following is an example output:

   Snmp=1 operationalState=ENABLED agentAddress host="0.0.0.0" port=161 SnmpTargetV3=OSS_v3

   In this example, the SNMP target SnmpTargetV3=OSS_v3 is to be deleted.

3. Enter Config mode:

   (Snmp=1)>configure

4. Delete the SNMP target, for example:

   (config-Snmp=1)>no SnmpTargetV3=OSS_v3

5. Commit the change:

   (config-Snmp=1)>commit

6. Verify that the SNMP target is deleted:

   (Snmp=1)>show -v

   Snmp=1 operationalState=ENABLED agentAddress host="0.0.0.0" port=161

   The SNMP target has been deleted.