Enable SNMP Target

1	Introduction
1.1	Prerequisites
2	Procedure

1 Introduction

This document describes how to enable a Simple Network Management Protocol (SNMP) target. An SNMP target is enabled when the managed element can be monitored by the corresponding management system as part of the normal operations.

1.1 Prerequisites

This section describes the prerequisites, which must be fulfilled before using the procedure.

1.1.1 Conditions

The following conditions must apply:

The SNMP target to enable is known and its operational state is DISABLED.
An Ericsson Command-Line Interface (ECLI) session in Exec mode is in progress.

2 Procedure

To enable an SNMP target:

Navigate to the Snmp managed object, for example:
>dn ManagedElement=NODE06ST,SystemFunctions=1,SysM=1,Snmp=1
Navigate to the SNMP target to be enabled, for example:
(Snmp=1)>SnmpTargetV2C=OSS_v2C

View the attribute settings of the SNMP target:

(SnmpTargetV2C=OSS_v2C)>show -v

The following is an example output:

SnmpTargetV2C=OSS_v2C
   address="192.0.2.10"
   administrativeState=LOCKED <default>
   community="public"
   informRetryCount=1 <default>
   informTimeout=300 <default>
   isMibWritable=true <default>
   operationalState=DISABLED <read-only>
   port=162 <default>
   snmpTargetV2CId="OSS_v2C"
   transportMethod=TRAP <default>

Note:: To enable the SNMP target, attribute administrativeState must be set to UNLOCKED. Attribute operationalState is then automatically set to ENABLED. The same is true for disabling SNMPv1 and SNMPv3 targets.

Enter Config mode:
(Snmp=1)>configure
Enable the SNMP target:
(config-SnmpTargetV2C=OSS_v2C)>administrativeState=UNLOCKED
Commit the setting:
(config-SnmpTargetV2C=OSS_v2C)>commit

Verify that the SNMP target is enabled:

(SnmpTargetV2C=OSS_v2C)>show -v

The following is an example output:

SnmpTargetV2C=OSS_v2C
   address="192.0.2.10"
   administrativeState=UNLOCKED <default>
   community="public"
   informRetryCount=1 <default>
   informTimeout=300 <default>
   isMibWritable=true <default>
   operationalState=ENABLED <read-only>
   port=162 <default>
   snmpTargetV2CId="OSS_v2C"
   transportMethod=TRAP <default>

The SNMP target is enabled.