Create SNMPv2C Target

1	Introduction
1.1	Prerequisites
2	Procedure

1 Introduction

This document describes how to create an SNMPv2C target. An SNMPv2C target is created to forward Simple Network Management Protocol (SNMP) notifications to a management system over the SNMPv2C protocol.

1.1 Prerequisites

This section describes the prerequisites, which must be fulfilled before using the procedure.

1.1.1 Conditions

The following conditions must apply:

The SNMP community and target IP address are known and according to the network IP plan.
An Ericsson Command-Line Interface (ECLI) session in Exec mode is in progress.

2 Procedure

To create an SNMPv2C target:

Navigate to the Snmp Managed Object (MO), for example:
>dn ManagedElement=NODE06ST,SystemFunctions=1,SysM=1,Snmp=1
Enter Config mode:
(Snmp=1)>configure
Create an SNMPv2C target, for example:
(config-Snmp=1)>SnmpTargetV2C=OSS_v2C
For the SnmpTargetV2C MO, set attributes community and address, for example:
(config-SnmpTargetV2C=OSS_v2C)>community=public

(config-SnmpTargetV2C=OSS_v2C)>address=192.0.2.10
Commit the settings:
(config-SnmpTargetV2C=OSS_v2C)>commit

Verify the settings

(SnmpTargetV2C=OSS_v2C)>show -v

The following is an example output:

SnmpTargetV2C=OSS_v2C
   address="192.0.2.10"
   administrativeState=UNLOCKED <default>
   community="public"
   informRetryCount=1 <default>
   informTimeout=300 <default>
   isMibWritable=true <default>
   operationalState=ENABLED [] <read-only
   port=162 <default>
   snmpTargetV2CId=OSS_v2C
   transportMethod=TRAP <default>