| Attributes |
integerKeyString
key
mandatory
noNotification
restricted |
-
vtasStod
-
This attribute is the primary key of the VtasStod managed object.
|
BasicAdmState |
-
vtasStodAdministrativeState
=
LOCKED
-
The administrative state of the STOD service is used to lock or unlock the service. When Unlocked, the MTAS provides the STOD service to end-user provisioned with the service. When Locked, the MTAS does not provide the Session Transfer to Own Device service.
Takes effect: New session
|
VtasDropBackDT |
-
vtasStodDropBack
=
USE_OTP_VALUES
-
This attribute allows the Virtual Telephony Provider (VTP) to use the values of the corresponding Operating Telephony Provider (OTP) attributes in MtasStod. When this attribute is set to "Use own values", the initial value of vtasStodHoldClearTimer attribute in VtasStod is set to the value of the corresponding mtasStodHoldClearTimer attribute in MtasStod, and the behavior of MTAS for the served users belonging to this VTP is determined by the values of the attributes of VtasStod. When this attribute is set to "Use OTP values", the behavior of MTAS for the served users belonging to this VTP is determined by the values of the attributes of MtasStod.
Takes effect: New session
|
MtasTimerSec00001to000020DT |
-
vtasStodHoldClearTimer
=
5
-
This parameter is connected to a timer which is started when a session is placed on hold. In order to trigger the STOD service, a Communication Hold must be followed by a BYE before this timer expires. If BYE is received after the expiry of this timer, then it is handled as a regular release of the held session.
Takes effect: New session
|
MtasString0to100DT
mandatory |
-
vtasStodPullByeReason
-
This attribute defines reason text for Reason header sent by the Call Pull service at BYE towards the old device being active in the call.The content of the attribute is copied to the reason text field of the Reason header. The value shall be added without quotation mark. If the value of vtasStodPullByeReason set to Call has been transferred to another device, then the Reason header in BYE message looks like:Reason: SIP; cause=200; text=Call has been transferred to another device.The protocol type and the cause code are non-configurable.If vtasStodPullByeReason attribute is empty then the BYE message does not contain the Reason header
Takes effect: New session
|
MtasString0to032DT
mandatory |
-
vtasStodPullProgressAnnName
-
The attribute defines the name of a generic announcement played to the pulling party when the call pull request has been accepted. If this attribute is empty or does not specify an instance of VtasGaAnn, no announcement is played.
Dependencies: The referred VtasGaAnn MOC instance must exist
Takes effect: New session
|
MtasString0to032DT
mandatory |
-
vtasStodPullRejectionAnnName
=
""
-
The attribute defines the name of a generic announcement played to the pulling party in case the call pull request has been rejected due to Call Pull service policies. If this attribute is empty or does not specify an instance of VtasGaAnn, no announcement is played.
Dependencies: The referred VtasGaAnn MOC instance must exist
Takes effect: New session
|