Contents

1   Introduction

This document describes how to create a measurement collection job. A new performance measurement collection job can be created by the user to collect performance data that is not currently collected on the managed element.

1.1   Prerequisites

This section describes the prerequisites, which must be fulfilled before using the procedure.

1.1.1   Conditions

The following conditions must apply:

• A unique PmJob Managed Object (MO) name is known. To check names already in use, refer to List Performance Management Jobs.

  The job name is POT_15min_Job in this document.

• The PmGroup or measurementType MO is known.
• An Ericsson Command-Line Interface (ECLI) session in Exec mode is in progress.

2   Procedure

To create a measurement collection job:

1. Navigate to the Pm MO, for example:

   >dn ManagedElement=NODE06ST,SystemFunctions=1,Pm=1

2. Enter Config mode:

   (Pm=1)>configure

3. Create a measurement collection job, for example:

   (config-Pm=1)>PmJob=POT_15min_Job

4. Set the PmJob initial state to ACTIVE:

   (config-PmJob=POT_15min_Job)>requestedJobState=ACTIVE

5. Perform one of the following options:
   • Create one or more MeasurementReader MOs with references to PmGroup MOs, for example:

     (config-PmJob=POT_15min_Job)>MeasurementReader=POT_mr

     (config-cMeasurementReader=POT_mr)>measurementSpecification

     (config-measurementSpecification)>groupRef="ManagedElement=NODE06ST,SystemFunctions=1,Pm=1,PmGroup=DbsPOT"

     Repeat these three commands as needed. One MeasurementReader MO is needed for each reference to a PmGroup MO.

   • Create one or more MeasurementReader MOs with references to measurementType MOs, for example:

     (config-PmJob=POT_15min_Job)>MeasurementReader=POTinst_mr

     (config-MeasurementReader=POTinst_mr)>measurementSpecification

     (config-measurementSpecification)>measurementTypeRef="ManagedElement=NODE06ST,SystemFunctions=1,Pm=1,PmGroup=DbsPOT,MeasurementType=PotInst.Count"

     Repeat these three commands as needed. One MeasurementReader MO is needed for each reference to a measurementType MO.

6. Commit the changes:

   (config-measurementSpecification)>commit

7. Verify the result:

   (MeasurementReader=POT_mr)>up

   (PmJob=POT_15min_Job)>show -v

   The following is an example output:

   PmJob=POT_15min_Job compressionType=[] <empty> currentJobState=ACTIVE <read-only> granularityPeriod=FIFTEEN_MIN <default> jobControl=FULL <default> <read-only> jobGroup=[] <empty> jobPriority=MEDIUM <default> jobType=MEASUREMENTJOB <default> pmJobId="POT_15min_Job" reportContentGeneration = CHANGED_ONLY <default> reportingPeriod=FIFTEEN_MIN <default> requestedJobState=ACTIVE <default> MeasurementReader=POT_mr