Stop Threshold Monitoring Job

1	Introduction
1.1	Prerequisites
2	Procedure

1 Introduction

This document describes how to stop a threshold monitoring job. In maintenance situations, the user can suspend a threshold monitoring job to avoid forwarding threshold alarms to the management system when the Managed Element (ME) is unstable and already given specific attention. This is also a way to reduce the load on the ME.

1.1 Prerequisites

This section describes the prerequisites, which must be fulfilled before using the procedure.

1.1.1 Conditions

The following conditions must apply:

The job name is known.
The job name is POT_Thr_Job in this document.
An Ericsson Command-Line Interface (ECLI) session in Exec mode is in progress.

2 Procedure

To stop a threshold monitoring job:

Navigate to the PmJob managed object, for example:
>dn ManagedElement=NODE06ST,SystemFunctions=1,Pm=1,PmJob=POT_Thr_Job
Enter Config mode:
(PmJob=POT_Thr_Job)>configure
Set the PmJob state to STOPPED:
(config-PmJob=POT_Thr_Job)>requestedJobState=STOPPED
Commit the PmJob configuration:
(config-PmJob=POT_Thr_Job)>commit

Verify the result:

(PmJob=POT_Thr_Job)>show -v

The following is an example output:

PmJob=POT_Thr_Job
   compressionType=[] <empty>
   currentJobState=STOPPED <read-only>
   granularityPeriod=FIFTEEN_MIN <default>
   jobControl=FULL <default> <read-only>
   jobGroup=[] <empty>
   jobPriority=MEDIUM <default>
   jobType=THRESHOLDJOB
   pmJobId="POT_Thr_Job"
   reportContentGeneration=CHANGED_ONLY <default>
   reportingPeriod=FIFTEEN_MIN <default>
   requestedJobState=STOPPED
   MeasurementReader=POT_mr