Contents

1   Description

This instruction describes how to view the state of automatic log streaming.

2   Procedure

2.1   View State of Automatic Log Streaming

Prerequisites

• No documents are required.
• No tools are required.
• The following conditions must apply:
  • Automatic log streaming has been successfully configured.
  • An Ericsson Command-Line Interface (ECLI) session in Exec mode is in progress.

Steps

1. Navigate to the Log managed object, for example:

   >dn ManagedElement=NODE06ST,SystemFunctions=1,LogM=1,Log=saLogSystem

2. Display the LogPushTransfer MO:

   (Log=saLogSystem)>show LogPushTransfer=1

   The following is an example output of streaming which is operational:

   (Log=ComCfgLogStream)>show LogPushTransfer=1 LogPushTransfer=1 availStatus DEGRADED operationalState=ENABLED transferType=STREAM uri="192.168.90.200:6154"

   The following is an example output of streaming which is disabled due to a fault:

   (Log=messages)>show LogPushTransfer=1 LogPushTransfer=1 availStatus IN_TEST LOG_FULL operationalState=DISABLED transferType=STREAM uri="192.168.90.200:6154"

   Note:  

   availStatus attribute is used to qualify why the operationalState attribute has changed its value. operationalState becomes DISABLED if one or more fault conditions are listed under availStatus attribute. The exception to this is the DEGRADED condition. If only DEGRADED is shown under availStatus, the operationalState remains ENABLED.