Start Threshold Monitoring Job

1	Introduction
1.1	Prerequisites
2	Procedure

1 Introduction

This document describes how to start a threshold monitoring job. A threshold monitoring job is started to enable the reporting of threshold alarms for the corresponding measurement types. This is usually done when the managed element is operational and manageable as part of the normal operations.

1.1 Prerequisites

This section describes the prerequisites, which must be fulfilled before using the procedure.

1.1.1 Conditions

The following conditions must apply:

The job name is known.
The job name is POT_Thr_Job in this document.
currentJobState for the job is STOPPED.
An Ericsson Command-Line Interface (ECLI) session in Exec mode is in progress.

2 Procedure

To start a threshold monitoring job:

Navigate to the PmJob Managed Object (MO), for example:
>dn ManagedElement=NODE06ST,SystemFunctions=1,Pm=1,PmJob=POT_Thr_Job
Enter Config mode:
(PmJob=POT_Thr_Job)>configure
Set the PmJob state to ACTIVE:
(config-PmJob=POT_Thr_Job)>requestedJobState=ACTIVE
Commit the PmJob MO configuration:
(config-PmJob=POT_Thr_Job)>commit

Verify the result:

(PmJob=POT_Thr_Job)>show -v

The following is an example output:

PmJob=POT_Thr_Job
   compressionType=[] <empty>
   currentJobState=ACTIVE <read-only>
   granularityPeriod=FIFTEEN_MIN <default>
   jobControl=FULL <default> <read-only>
   jobGroup=[] <empty>
   jobPriority=MEDIUM <default>
   jobType=THRESHOLDJOB
   pmJobId="POT_Thr_Job"
   reportContentGeneration=CHANGED_ONLY <default>
   reportingPeriod=FIFTEEN_MIN <default>
   requestedJobState=ACTIVE <default>
   MeasurementReader=POT_mr

Note:: An alarm notification is issued at the end of the reporting period if thresholdHigh in the PmThresholdMonitoring MO has been exceeded.