Contents

1   Introduction

This document describes how to modify the name of the health check job to be triggered if the job execution detects a Managed Element (ME) status different from HEALTHY.

1.1   Prerequisites

This section describes the prerequisites, which must be fulfilled before using the procedure.

1.1.1   Conditions

The following conditions must apply:

• The name of the health check job for which the job to trigger must be modified is known. For a description of how to create a job, refer to Create Health Check Job.
• The DN of the health check job to be triggered is known. For a description of how to create the job, refer to Create Health Check Job.
• An Ericsson Command-Line Interface (ECLI) session in Exec mode is in progress.

2   Procedure

To modify a job to trigger:

1. Navigate to the HealthCheckM Managed Object (MO):

   >dn ManagedElement=<node_name>,SystemFunctions=1,HealthCheckM=1

   Note:  

   The string node_name is specific for the ME.

   
   
2. Navigate to the HcJob MO representing the health check job for which a job to trigger is to be modified , for example:

   (HealthCheckM=1)>HcJob=jobName

3. Show jobToTrigger attribute:

   (HcJob=jobName)>show jobToTrigger

   The jobToTrigger attribute is shown.

   The following is an example output:

   (HcJob=jobName)>jobToTrigger="ManagedElement=1,SystemFunctions=1,HealthCheckM=1,HcJob=thirdJob"

   Note:  

   The jobToTrigger attribute is empty by default.

   
   
4. Enter the configure mode:

   (HcJob=jobName)>configure

5. Set the jobToTrigger attribute:

   (HcJob=jobName)>jobToTrigger="<job_to_triggerDN>"

   The string job_to_trigger_DN is the valid DN of a HcJob MO. It must be in quotation marks.

6. Commit the operation:

   (config-HcJob=jobName)>commit

   If the commit is unsuccessful, an error message is printed. Possible causes of failure are the following:

   • job_to_trigger_DN is not the valid DN of a HcJob MO.
   • job_to_trigger_DN is the valid DN of the HcJob MO for which the job to trigger is to be set. A job cannot trigger itself in a recursive way.
7. Check the jobToTrigger attribute value:

   (HcJob=jobName)>show jobToTrigger

   The jobToTrigger attribute value shown is the one previously set.

   The following is an example output:

   (HcJob=jobName)>jobToTrigger="ManagedElement=1,SystemFunctions=1,HealthCheckM=1,HcJob=secondJob"