Contents

1   Introduction

This document summarizes the procedure for disabling/enabling vFuel on a Single Server environment.

1.1   Description

vFuel manages the CEE infrastructure life cycle and runs in a separate virtual machine on CentOS Linux.

vFuel is responsible for the following:

• Installation of the CEE software
• Updates of the CEE software
• Adding and removing hardware resources

To save resources on a single server environment, vFuel is not migrated to the production environment but it is switched off on the installation host or laptop. vFuel can be reactivated when needed, for example: to add new packages on vCIC or Compute nodes, or to do an update.

1.2   Prerequisites

The Cloud Execution Environment (CEE) is installed by using CEE Installation, as described in CEE Installation.

2   Procedure

vCIC and Compute nodes run several services or use configurations related to vFuel, as follows:

• Mcollective service
• Nailgun agent
• DNS configuration

Disabling vFuel stops these services and removes all related configurations. Before any update or modification of the environment, vFuel needs to be enabled again.

2.1   Disable vFuel

To disable vFuel, proceed with the following steps on vFuel as root user:

1. Execute the following commands:

   cd /usr/share/ericsson-orchestration/playbooks

   openstack-ansible fuel-disable.yml

   The expected output shows only ok and changed statuses and no failed at PLAY RECAP.

   Example:

2. Switch off the vFuel Virtual Machine (VM) by executing the following command:

   shutdown -h now

   Using Linux libvirt the VM is listed as shut off:

   root@compute-0-1:~$ virsh list --all
    Id    Name                           State
   ---------------------------------------------------
    -     fuel_master                    shut off

vFuel is now disabled. Enabling again is described in Section 2.2.

2.2   Enable vFuel

To enable vFuel again, proceed with the following steps. All commands entered on vFuel should be run as the root user.

1. Switch on the vFuel VM on the Linux or Windows installation laptop by executing the following commands:
   1. Using Linux libvirt, get the <vm name> by executing the following command:

      virsh list --inactive

   2. Start the vFuel VM by executing the following command:

      virsh start <vm name>

2. Log on to the restarted vFuel and ensure that the Fuel services have started successfully by executing the following command:

   fuel-utils check_all

   Note:  

   Following a system startup vFuel needs time to initialize services.

   
   
3. Some more minutes are needed for vFuel to start operating.

   To check if vFuel is operational, execute the following command:

   fuel node

   Note:  

   It can be necessary to execute the command several times, until it is successful.

   
   

   The expected output contains a properly formatted table with the node list.

   Note:  

   The nodes online value will remain False until vFuel is re-enabled.

   
   

4. On vFuel, execute the following commands to enable it:

   cd /usr/share/ericsson-orchestration/playbooks

   openstack-ansible fuel-enable.yml

vFuel is enabled again.

The expected output shows only ok and changed statuses and no failed at PLAY RECAP.

Example: