AirOS F Firmware Revision History
====================================================================
Supported products

  * airFiber 3X

====================================================================
Changelog:

--------------------------------------------
Version 4.0 (August 29th, 2017)
--------------------------------------------

New Features:
- All New GUI
- Receive Target Power (control tx power to hit remote receive target)
- Slave Frequency Scanning (autoscan of up to 10 frequencies looking for beacon)
- Immediate changes for Basic Wireless Settings; RF link maintained where possible
- Added strict timing mode for improved co-location

Improvements:
- Full password length now used (not just first 8 characters) for both web and ssh/telnet
- Addressed issue with unstable (periodic) links when using VLAN priorities
- Improved RF filtering / adjacent signal rejection
- Ethernet Carrier drop now has high and low trigger points, new timers, etc.
- Various Security Updates

Known Issues:
- Spectrum Analyzer still Java based
- If your configuration has ALL three of the characteristics listed:

 1. You have inband management disabled
 2. You have a management VLAN enabled
 3. You manage a remote radio (far side of an airFiber RF link) by connecting the remote data port to the management port either directly or through a switched network

you will need to enable inband management on the remote radio BEFORE you upgrade. After the upgrade, you can then reconnect to the remote radio and disable inband management. Failure to do so will leave the remote radio unmanageable over the RF link (local access via the management port will still function normally). 

Notes:
- Recommend updating far end of link before near end
- Only first 8 characters of old passwords are used after update - must reconfigure for longer passwords


--------------------------------------------
Version 3.2 (Nov 30, 2015)
--------------------------------------------
New Features:
- 10x modulation support

Improvements:
- n/a

Fixes:
- Automatic power backoff now works as expected
- Addresses vulterability that could allow unauthenticated users to gain access to the device via HTTP(s). All users should update immediately.
- AirView launch defaults to download and run locally
- Automatic power backoff uses new defaults
- Automatic power backoff added set defaults button

Known Issues:
- SSH password only use first 8 characters of login password

Notes:
- Previous values for Automatic Power Backoff will be defaulted
- Recommend updating far end of link before near end


--------------------------------------------
Version 3.1.1-rc1 (Jul 22, 2015)
--------------------------------------------

Factory Release