
            D-Link DGE-550T Gigabit Ethernet Adapter Installation
                           for Windows NT V4.0


 Getting Started
 ---------------

    - Start your Windows NT 4.0 PC normally and inserting the network
      adapter into your computer.

    - Open "My Computer" -> "Control Panel" -> "Networks" icons.

    - Select "Add adapter" -> "Have disk" items.
      Type the following (assume the driver is located at A:\)

            A:\    (A: is floppy drive)
			OR 
            D:\    (D: is CD drive)

      Select the "D-Link DGE-550T ...".

    - Windows NT 4.0 will copy the driver files from the driver disk.
      It also will pop up the configuration window, you can assign the
      "Connection Type" and "Network Address" here.

    - After finishing file copy, Windows NT 4.0 will ask you to
      reboot the PC. Select YES.

    - Restart the computer.


    Driver keywords:
    ----------------

    - Open "My Computer" -> "Control Pannel" -> "Network" ->
      Double click "D-Link DGE-550T ..."

      Connection Type   Specify the connection type for the adapter.
                        Default: AutoSense

      Network Address   You can set the Ethernet address for your adapter.
                        It is not recommended to use this keyword. Please
                        use default value if possible.
                        As you know two or more adapter in the same
                        network with same Ethernet address will cause
                        a little problem.

                        When using this keyword you need to input exactly
                        6 bytes of Ethernet address using one of the
                        following format:

                             xx-xx-xx-xx-xx-xx
                           OR
                             xxxxxxxxxxxx

                           Default: read address from adapter ROM.

       802.1Q/1P VLAN       You can enable it for VLAN group.
       tagging              Default: Disabled

       VLAN ID              This value will active after 802.1Q/1P VLAN
                            tagging enable.

       GVRP                 Support GVRP and will active after 802.1Q/1P
                            VLAN tagging enable.
                            Default: Disabled
                            
       Jumbo Frame Support  You can enable this for Jumbo frame support.
	   		    Default: Disabled
	   		    (The device or link partner should also support
	   		    Jumbo frame for this function to take effect.)
	   						